Press "Enter" to skip to content

NBN Fiber is Active

I finally managed to get NBN Fiber activated at my place. I have purchased a Cisco 5506-X to service the NBN Link to terminate 2 x 100/40mb services as this is the max available speed per carrier. I plan on using the Policy Based Routing function on the Cisco 5506-X to load balance the links a bit and setup traffic types and how it should flow. I will later document my config of the Cisco and the funky type PBR I have setup on it.  The NBN box offers 2 voice ports and 4 ethernet ports. The 4 Ethernet Ports can provide up to 4 ISPs to service the traffic to your premise. Since I have dual links at present techincally I have a 200/80 link load balanced on the ASA which is quite nice 🙂

Here are some of the photos of my setup and how its functioning, in a later post I will go through the 5506-X configuration.

Cisco ASA 5506-X
Cisco ASA 5506-X on NBN
NBN Switch and Battery Backup
NBN Switch and Battery Backup
NBN Battery Backup
NBN Battery Backup
NBN Switch
NBN Switch, LEFT: 2 voice ports, MIDDLE: 4 Ethernet Ports, RIGHT: Fiber Optic Cable termination
Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.